Tools and Accessories
C-11 - Combination Can Punch and Countersink
The C-11 Combination Can Punch and Countersink is used to punch a hole and
provide a flattened surface
to permit installation of the C-5 and C-9
thermocouple receptacles.
The C-11 is a two piece draw through construction
that requires a pilot hole to be made with an awl (C-15).
In addition to
being cost-effective, it can be used on the can end as well as the can side.
C-12 - Lever Type Can Punch
The C-12 Lever Can Punch can be used only on the side of a can or to punch a
hole in a can or jar lid
before sealing the lid to a the container. It does
not require a pilot hole.
If you anticipate numerous tests and are inserting
the thermocouple in the side of the can,
the C-12 offers speed and
convenience.
C-12-EM - End Mount Lever Type Can Punch
The C-12-EM End Mount Lever Can Punch is used to punch a hole in the deep
bottom of a can for end mounting. Included is a centering disk for different
can sizes; it does not require a pilot hole.
C-13 - End Wrench
The C-13 End Wrench has a 3/4” end for tightening the C-5 and C-9
thermocouple receptacles.
Note: A separate end wrench
is available upon request with a 7/16” end for tightening the C-5.2
stuffing box and the C-8 packing nut.
C-14 - Spanner Wrench
The C-14 Thermocouple Spanner Wrench was designed specifically to tighten
the thermocouple in the receptacle. Proper sealing of the thermocouple
requires only the fingers of the technician.
A wrench should never be
used on the spanner wrench.
C-14-S - Spanner Wrench with Handle
The C-14 Thermocouple Spanner Wrench was designed specifically to tighten
the thermocouple in the receptacle
and provides an easy to use screwdriver
handle.
C-15 - Awl
The C-15 Awl is used to make a pilot hole for the C-11 Combination Can Punch
and Countersink.
The Awl has a shaft diameter of 1/4” (6.4 mm).
2010 Ecklund-Harrison Technologies Inc. All Rights Reserved